USB Type-C: A standardized USB connector; benefits include the compact, sleek, and reversible design. USB Power Delivery: A specification that allows the load and power supply to negotiate for multiple standard power delivery levels. USB Power Delivery increases USB's power capability to 100 W and is particularly useful when providing power to USB 2.0 is the minimum. Furthermore, more and more laptop and desktop computers are shipping with USB-C as well. C-to-C cables would be useful to connect your phone in those cases. The same explanation applies for A-to-C cables as for C-to-C cable. The USB 3.2 variants of such cables are more expensive and shorter. USB Type-C: USB Type-C is one of the newest standards for USB cables. They have a thin, oval-shaped metal connector (8.24mm x 2.4mm). They support all USB standards. Some USB cables have a USB Type-A plug on one end and USB Type-C on the other end. Apple cables may have a USB Type-C on one end, and a Lightning connection type on the other end. 2.0, USB 3.2 and USB4™ (as defined in the USB Type-C spec) 17 Precedence Mode of Operation Nominal Voltage Maximum Current Highest USB PD (including USB4) Configurable 5 A ↓ USB Type-C Current @ 3.0 A 5 V 3.0 A USB Type-C Current @ 1.5 A 5 V 1.5 A USB BC 1.2 5 V Up to 1.5 A Default USB Power USB 3.2 x2 operation 5 V 1,500 mA*

The USB Type-C Specification 1.0 was published by the USB Implementers Forum and was finalized in August 2014. It repeats roughly the same time as the USB 3.1 specification. Communication is full-duplex during SuperSpeed. In the compatibility mode (USB 1.0 or USB 2.0) communication is half-duplex, with direction controlled by the host.

USB Type-A is used to make a connection with a PC while Type B is used to connect smaller peripherals. In other words, Type A is a downstream connector, while Type B is an upstream connector. The USB type A has rectangular, while type B has a square-like shape. Both of them have 4 pins. The figure below shows the Pinout of Male and Female With this cable, you have VBUS, GND and CC. The charger itself has the USB CC pullup resistor and monitors the CC voltage for other power profiles. Your plan is converting this to an USB C plug to micro USB plug (data & power left to right). You would need to remove the CC wire from the PCB and wire it up via an 5.1K resistor to ground. Shoo.
  • ow7bet8rg9.pages.dev/388
  • ow7bet8rg9.pages.dev/263
  • ow7bet8rg9.pages.dev/133
  • ow7bet8rg9.pages.dev/375
  • ow7bet8rg9.pages.dev/77
  • ow7bet8rg9.pages.dev/309
  • ow7bet8rg9.pages.dev/212
  • ow7bet8rg9.pages.dev/37
  • ow7bet8rg9.pages.dev/272

    • how many wires in usb c cable